Install a Jasion Ebike Pannier Rack Bag

Quick answer

Mount your Jasion Ebike Pannier Rack Bag by aligning the hooks with your rear rack rails, securing the straps, and tightening the lower stabilizer bar.

Installation steps

1. 1. Attach the upper hooks: Open the hook-and-loop straps on the back of the bag. Hook the two plastic clips over the top rail of your rear rack, one on each side. Common mistake: hooking them too far inward can cause the bag to tilt toward the wheel.
2. 2. Tighten the hook-and-loop straps: Pull each strap snug around the rack rail. Make sure both sides are equally tight so the bag hangs level. Checkpoint: if the bag sags to one side, loosen and re-tighten the lower strap on the drooping side. A level bag distributes weight evenly and prevents rubbing against the wheel.
3. 3. Secure the lower stabilizer bar: Locate the small plastic bar with two holes at the bottom of the bag. Thread the included strap through the holes, then wrap it around the lower rack rail and fasten it. Common mistake: skipping this step lets the bag swing forward when you brake.
4. 4. Check clearance: Spin the rear wheel by hand. Listen for any scraping sounds from the bag against the spokes or frame. If you hear contact, adjust the bag's position or tighten the lower stabilizer strap further.
5. 5. Load and test ride: Place your heaviest items at the bottom of the bag, close to the rack. Take a short ride in a parking lot or quiet street, making sharp turns and hard stops. Re-tighten any straps that feel loose after the ride. Recheck the straps after the first ride – they often loosen slightly as the bag settles.

Product facts

• Jasion Ebike Rack Pannier Bag: Compatible with standard rear bike racks for easy mounting. You don't need special tools or adapters – the bag clips onto most common rack designs right out of the box.